Flow hood question

Started by tlj1011, May 14, 2009, 09:30:12 AM

Previous topic - Next topic

tlj1011

Hi, I'm new to this board and I have a question:


After losing a few cultures to contamination...I've decided to invest in building a small flow hood.

I found a 12" x 12" HEPA Filter, and according to the guide here:

area of the filter (1ft^2) x 100 ft/min (the required air speed) =

the required air my blower has to deliver against 1"(250 Pa) of static pressure (my filter has a static pressure of .8" and the pre-filter has a static pressure of .2") is 100 cfm ( or 170 m^3/h )


So I need a blower that outputs at least 100 cfm at 250 Pa of static pressure...

I found one here on ebay for a pretty low price.

Will this get the job done?

FurnaceZer

I am not good to that thing but i know someone that can help you I will post again if I can contact or talk to him.,he is not in place he left just this last week.,




_________________
Furnace Filter


psilocybin warrior

If it says it will put out the #'s your need I see no reason why It could not get the job done.

PW