Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - JaRRn

#1
PF - Tek / 7 from 10
July 29, 2004, 07:13:48 PM
Ok Ive started my first go at the PF-Tek 4 Simple Minds.  I had to make me own syringes from a print, (Ralphsters  :D )

So far 2 of the slower jars have Green Contam  one of the fast ones 90% got black contam.   (Im using a PC) ** I chucked out the bad ones **

Black stuff just ripped throught the Myc in 2 days started as a dot then just ripped through like a storm.

19days since Inncoulation 7 of 10 are 98-100% colonised! :)

Why is it that all 10 where made at the same time and 3 contaminated ?

What could of caused that ?  May the needle hit a bug in the air or I had a couple of bugs land in my spore solution when I made it ? *Oven Tek*

Annoying but atleast I get to make up some more jars again!
#2
PF - Tek / Humidity
June 02, 2004, 07:09:31 PM
Are the humidity levels to remain the same once the cakes hit the terrarium.
Or where can I find a very informative piece written on the temp and humidity levels, through out all the satges.  Im yet to begin, but Im going to do a dry run first to see how the temp and humidity levels go.  I see if I get them right then I should start not fumble along the way.

Ta. :lol:  
#3
PF - Tek / Temperature
May 21, 2004, 09:03:24 PM
Temperature:


Though out the entire process from jar to terrarium is the Temperature to remain on 30degrees (86f).  

#4
General topics / Turd and Mushrooms
May 20, 2004, 10:53:55 PM
Do many Poisonous Species of Mushrooms grow in cow turd ?

Or is it a pretty safe bet if they display the basic signs of being magic :D , they probably will be ?


Any help greatfully appreciated
#5
PF - Tek / Spore Printing.
May 19, 2004, 02:17:20 AM
Hi all,

Im just wondering about hows the best way to spore print and get my samples into a syringe.  I have too get my own wild specimens to begin this process.  I have just read that you can Spore print in a glass Jar and then add your water to it and do it that way.  Also keep some spore prints on paper for later use aswell.

I cant remember where I just found this info, any help to set me in the right direction would be greatly appreciated!


Cheers

JaRRn  :D