Fungifun - Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

SMF - Just Installed

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - emick

Pages: [1]
1
PF - Tek / Re: AT LAST
« on: October 09, 2009, 07:52:07 PM »
Got it (I think)--poly for the vent hole, RTV Silicone for the inoculation holes?  Plastic lids are a good idea.  I have a few dozen Kerr 1/2 pint wide mouth jars but only have the standard lids for them--know anyplace that sells plastic lids that will fit em?

2
PF - Tek / Re: AT LAST
« on: October 09, 2009, 08:53:54 AM »
Camelton,

quick question re: your self-healing inoculation holes...

I thought one of the benefits of having the 4 holes as described in the PF tek was to allow for gas exchange.  By putting silicone over the holes, aren't you eliminating or limiting the possibility of this exchange?

Also, I wasn't clear from your explanation what you were descibing.  Do you put silicone on each side of the lid with poly in the middle?

Pages: [1]