Fungifun - Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

SMF - Just Installed

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Vandal_xx

Pages: [1] 2 3 ... 16
1
Cultivation / Re: Is this contamination??
« on: October 18, 2012, 05:36:11 AM »
Hard to tell, but I'm sure you know by now. Good luck.

2
PF - Tek / Re: First B+ batch was a total flop - Help needed!
« on: May 27, 2012, 12:35:39 PM »
Temp might be an issue. If it isn't over 70 the growth will be extremely slow and may even stall out. Did you use BRF? How did you sterilize? Were they in complete darkness.

3
Cultivation / Re: anti-biotics in agar culture?
« on: March 29, 2012, 05:52:37 AM »
I would just use em and hope for the best. If there are contams then you are screwed either way. Give em a shot. Who kows.

4
PF - Tek / Re: A newb question (print -> syringe)
« on: March 22, 2012, 09:10:24 AM »
I messaged you. sorrry for the dealay.

5
I just use a little lysol about an hour before inside my glove box before I use it. Good luck. A little trial and error goes a long way.

6
Cultivation / Re: Feedback on my fruiting chamber
« on: March 13, 2012, 05:25:05 PM »
Dude, I use a plastic container with perlite and just mist and fan. Not too sure of your setup. Maybe too much for a first attempt?? Good luck though.

7
1...I have town water, It is not chlorinated and just from a resivoir. I would use bottled water if you don't have a well.
2....same as #1. If your water is treated, buy some.
3...should be okay. I use regular rubbing alcohol. Just be sure it is all evaporated before you add/do anyhing.
4....I don;t use gloves. If they have been fully colonized plus a week they will not conataminate easily.
5...Yes 2-3 more times. Dunk and roll after every harvest. Pic all growth off before dunking again.
 Allow indirect sunlight and you should be okay. Patence is key in this!!!!! PM me for more help

8
Every once in a while I have one out of a batch that gets contams. Just a part of the hobby if you are like me and dont have a lab to work in. It is a miracle more jars are't ruined. Also, I have heard you can boil the shit outta a contamed jar, then dump it outside and clean with alcohol and you should be able to get out all the GREANIE. I just choose to chuck mine though, good luck

9
Cultivation / Re: GREEN MEANIE OR BLUE BOY BRUISING?
« on: March 12, 2012, 04:27:34 PM »
dude, looks like that sucker is dry or something. The blue means it is in distress. From the pic I think that is what you have going on there.

10
Cultivation / Re: funny albino shroom
« on: March 08, 2012, 05:32:45 PM »
sweet

11
Cultivation / Re: 17 days no pins, critique setup please
« on: March 08, 2012, 05:31:15 PM »
Dude, temp is too low. They will take a long time to pin. Use a big container half filled with water and an aquarium heater stuck to the bottom. Silicone up the holes on the bottom of your FC and put it in the water. Use a couple of jars or something in the bottom of the water so the FC isn't floating. Make sure you throw a themometer in the FC until you get the temp dialed in.

12
PF - Tek / Re: inoculate with Fresh fruit body?
« on: December 12, 2011, 02:31:18 PM »
Or you can switch to grains and just do a jar to jar transfer.

13
PF - Tek / Re: Fruiting Questions (with pics)
« on: September 08, 2011, 11:32:04 AM »
how cold is your chamber? if it is less than about 65, it will take a bit longer, IMO

14
Cultivation / Re: BabyBlue Grow Log 1
« on: May 23, 2011, 06:17:39 AM »
ahh yes, a new batch, what a good idea!

15
Cultivation / Re: Liquid Culture growth
« on: May 23, 2011, 06:14:35 AM »
I gotta start doing that, I'm sick of making prints, syringes. nice work.

16
Cultivation / Re: BabyBlue Grow Log 1
« on: May 13, 2011, 06:44:27 AM »
first off it will take at least 5-6 days to see some growth. I would avoid heating your jars. the temp in your place is 68-70F you will be just fine. Many other first time growers have heated and killed their jjars. Good luck

17
PF - Tek / Re: First grow (unfinished) (pics)
« on: May 13, 2011, 06:39:25 AM »
awesome man, beautifull location.

18
PF - Tek / Re: white fluffy mould....Verticillium??
« on: May 12, 2011, 06:21:01 AM »
Yeah, trash. Don't even open it up. If you need to reuse the jars boil them before youi empy them or do it outside so mold spores don't fly all over your house.

19
PF - Tek / Re: white fluffy mould....Verticillium??
« on: May 10, 2011, 01:17:17 PM »
yeah, not too sure what that is. Better be safe than sorry.

20
Cultivation / Re: harvesting
« on: May 05, 2011, 06:23:31 PM »
Exactly

Pages: [1] 2 3 ... 16